1996 KTM 250 300 360 Motocross Enduro Motorcycle Owners Handbook

Description

This 70 page, 1996 KTM 250 300 360 Motocross Enduro motorcycle Owners Handbook is an authorized reproduction of the original, out of print manual. It will furnish you with important information on how to operate and maintain your KTM motorcycle. Many motorcyclists have a good working knowledge of motorcycle mechanics; if this is true in your case, you will be able to use this manual to carry out most of the maintenance steps yourself. If, on the other hand, you are not very familiar with motorcycles, it might be better to have a professional KTM dealer perform those steps marked by found in the chapter entIt ed Maintenance Work on Chassis and Engine of this manual. Take special care to follow the recommended run in, inspection, and maintenance intervals. Heeding these guidelines will significantly increase the life of your motorcycle. Have services carried out by a KTM dealer so that your warranty claim remains intact.

Table of Contents

INTRODUCTION
SERIAL NUMBER LOCATIONS
Frame number
Engine number, engine type
Ignition key
Steering head lock key
OPERATION INSTRUMENTS
Clutch control lever
Hand brake lever, setting of pressure point
Speedometer, control lamps (EXC)
Odometer (EXC USA}
Speedometer, control lamps (EGS)
Ignition lock
Short circuit button (SX)
Combination switch (EXC)
Headlamp switch /EXC USA)
Combination switch (EGS)
Filler cap
Fuel
Fuel tap
Choke knob
Shift lever
Kickstaner
Foot brake pedal
Compression damping of fork
Rebound damping of fork
Compression damping of shock absorber
Rebound damping of shock absorber
Handlebar lock
PRE-OPERATION INSTRUCTIONS
DRIVING INSTRUCTIONS
PERIODIC MAINTENANCE SCHEDULE
MAINTENANCE WORK ON CHASSIS AND ENGINE
Check and adjust steering head bearing
Chain tension, chain maintenance
General informations about KTM disc brakes
Checking of brake fluid level front brake
Refilling the front brake reservoir
Check the front brake pads
Replace front brake pads
Changing the basic position of the foot brake pedal
Checking brake fluid level rear
Refilling the rear brake reservoir
Checking the rear brake pads
Replacing the rear brake pads
Dismounting and mounting the front wheel
Dismounting and mounting the rear wheel
Tires, air pressure
Checking spoke tension
Replacing head light lamp (H4)
Fuse (A, AUS, CH)
Battery (A AUS, CH)
Cooling system
Coolant level check
Bleeding the cooling system
Cleaning the airfilter
Exhaust system
Cleaning the spark arrestor (250/360 EXC USA)
Carburetor adjustment
Check float level
Checking transmission oil level
Changing transmission oil
Adjusting clutch cable
CLEANING
STORAGE
TECHNICAL SPECIFICATIONS / CHASSIS
Torques
Standard adjustment fork and shock absorber
WIRING DIAGRAM