International Harvester Farmall 140 Tractor Service Manual

Description

This 200 page, International Harvester Farmall 140 factory service manual is a reproduction of the original, out of print manual. This tractor repair manual provides detailed service information, step-by-step repair instruction and maintenance specifications for International Harvester Farmall 140 tractors.

This manual includes comprehensive engine and fuel system information for International Harvester Farmall c-123, c-135, c-146 and c-153 engines. Both gasoline and LP powered tractor motors are covered by this manual and in great detail. Below are the Table of Contents for this manual – we hope this is helpful in determining if this manual will apply to the work you are trying to accomplish.

Table Of Contents

Front End
Wheel Hub Assembly
Removal And Disassembly
Inspection
Reassembly And Installation
Steering Knuckle Assembly
Removal
Inspection
Installation
Steering Gear Housing Assembly
Removal And Disassembly
Reassembly And Installation

Splitting And Recoupling
Front End Split
Engine Removal
Transmission Clutch Split
Clutch Removal
Installation
Engine Clutch Adjustment
Rear Section Split
Adjusting The Toe-In

Final Drive Assembly
Removal
Disassembly
Inspection
Reassembly And Installation

Transmission And Pto Assembly
Transmission Assembly
Removal
Disassembly
Inspection
Reassembly And Installation
Power Take-Off Unit

Hydraulic System
Specifications
General Description
Cleaning
Handling Of O-Rings
Principles Of Operation
Hand Control Levers And Rockshaft
In Neutral Position
Hand Control Levers Moved To Lower Implement
Hand Control Levers Moved To Raise Implement
Removal
Disassembly
Reassembly
System Pressure Check
Hydraulic Pump Test
Stop Clip Adjustment
Troubleshooting
Touch Control Block Schematic
Electrical
Electrical Schematics For Tractors With:
Serial Number 57724 And Above
Serial Number 45001 To 57723
Serial Number 26801 To 45000
Serial Number 26800 And Below
Specifications

Engine
Specifications
Service Procedure
Valve Timing
Valve Lash Adjusting Procedure
Mounting The Engine To The Stand
Cylinder Head And Valves
Timing Gear Train And Front Cover
Camshaft
Crankshaft
Piston Fit In Bore
Cylinder Sleeves
Crankcase Cylinder Re-Boring Procedure
Engine Governor
Lubricating Oil Pump
Water Pump
Break-In Procedure Of Rebuilt Gasoline And Lpg Engines
Gas Engines
Lpg Engines
Run-In When Dynamometer Is Not Available
Run-In When Dynamometer Is Available
Gasoline Fuel System
Carburetor Specifications
Carburetors
General Description
Operation
Fuel Supply System
Idling System
Load System
Starting System
Liquid Level Check (Carburetor On Engine)
Removal And Installation
Inspection And Repair
Throttle Body And Fuel Bowl
Throttle Plate
Float Assembly
Fuel Needle Valve And Seat
Adjusting Screws
Venturi And Jets
Assembly And Adjustment
Lpg Fuel System
Specifications
Safety Precautions
General Description
Operation
Fuel Tank And Fittings
Fuel Filter Assembly
Carburetor And Regulator Vaporizer
Engine Stopped – Fuel On
Starting
Idling
Part Throttle
Full Throttle
Troubleshooting
Regulator-Vaporizer Service
Removal And Installation
Inspection And Repair
Assembly And Adjustment
Regulator Testing
Carburetor Service
Removal And Installation
Inspection And Repair
Fuel Adjustments